BC7 BATCH CONTROLLER    

The BC7 will automatically deliver a preset quantity of liquid and show you the flow rate and batch quantity.


Quick and easy to set up
Just press the start button
Large easy to read displays
Preset to your requirements
Automatically compensates for errors
Save time, reduce waste and costs
Improve product quality
No flow alarm
Safely shuts down if your flow is interrupted
Works with most flowmeters

Application
This instrument has a huge range of uses, from container filling to tanker loading.You can use it to deliver any preset quantity of liquid accurately and reliably

Operation
To start a batch you just press the run button. One display will show you the batch count whilst the other can be set to show either the flowrate or the preset batch quantity.
You can use the BC7 in two ways.
1 : Single relay operation. The run button operates a relay to control a valve or pump, which is automatically shut off at the end of the batch.
2 : Double relay operation where 2 relays can be used independantly to control valves and pumps for slow start and slow stop applications.
Two LED’s show you when either of the two relays are energised. The signal can be used for a local display, remote display or converted for transmission to a separate control system. Apollo have a range of instruments to suit all your requirements.

Installation and Setup
The displays can be set for any units e.g. litres or gallons. The setup is easy using the keypad and a beep is sounded with all keystrokes. The BC7 can be supplied preconfigured for your application.
Operator access to the setup menu can be inhibited.

Features
Overrun compensation: The controller can automatically compensate for errors caused by slow acting valves and deliver exactly the volume you want.
No flow alarm: If there is a problem and the signal from the flowmeter stops an alarm will be given and the batch will be stopped.
Linearisation: The accuracy of your system can be improved by programming any flowmeter errors into the BC7.
There is a non resettable total to allow you to monitor long term usage.

Construction
The Batch Controller is in a standard 1/4 DIN format to mount in a panel.
The front keypad is a sealed unit which provides you with a splash proof seal that is resistant to most chemicals.

Specification

 Input signals:

 Outputs:

 Front Panel Controls:

“Run” Activates the relays to start the batch.
“Stop” If pressed during batching the process will be interrupted. The batch can then be continued by pressing the “RUN “ key or the sequence can be aborted by pressing the “RESET” key.
“Reset” The instrument batch quantity is reset.
“Batch Set” Allows an operator to change the preset quantity.
LED Status lights:
Relay 1: The red relay 1 LED lights when relay 1 is energised
Relay 2: The red relay 2 LED lights when relay 2 is energised
Alarm: The alarm LED lights when a no flow alarm condition has been detected.The Batch Controller is in a standard 1/4 DIN format to mount in a panel.
The front keypad is a sealed unit which provides you with a splash proof seal that is resistant to most chemicals.

Click below to switch to the following flowmeters:
BC7 Batch Controller | RT7 Rate Totaliser |202 Rate Totaliser | 214i Batch Controller | RTB Rate Totaliser | WFC5 4-20 mA Converter | WS5 Flowmeter Scaler | FC7 F to I Converter | Sensors & Amplifiers |